QJ Pyraminx corner caps.

The general idea is correct, yes. It's hard to tell, but I think the knife is too deep. If you look under the tip, you'll see you have very little room to work with. You need to barely stick the knife in so that it holds onto the cap and doesn't slip out, but also is not pulling on the piece that's held on by the screw.

Also, I believe this kind of pyraminx has very little glue. Just keep repeating this on all three sides to loosen the cap and it should eventually pop off. Of all the pyraminx puzzles that I have, I think this kind was the easiest one to get caps off of.
 
The general idea is correct, yes. It's hard to tell, but I think the knife is too deep. If you look under the tip, you'll see you have very little room to work with. You need to barely stick the knife in so that it holds onto the cap and doesn't slip out, but also is not pulling on the piece that's held on by the screw.

Also, I believe this kind of pyraminx has very little glue. Just keep repeating this on all three sides to loosen the cap and it should eventually pop off. Of all the pyraminx puzzles that I have, I think this kind was the easiest one to get caps off of.

I move my wrist like accelerating a motorcycle right?
 
The general idea is correct, yes. It's hard to tell, but I think the knife is too deep. If you look under the tip, you'll see you have very little room to work with. You need to barely stick the knife in so that it holds onto the cap and doesn't slip out, but also is not pulling on the piece that's held on by the screw.

Also, I believe this kind of pyraminx has very little glue. Just keep repeating this on all three sides to loosen the cap and it should eventually pop off. Of all the pyraminx puzzles that I have, I think this kind was the easiest one to get caps off of.

I move my wrist like accelerating a motorcycle right?

Yes, that should do it. Sometimes it does take a while...
 
The general idea is correct, yes. It's hard to tell, but I think the knife is too deep. If you look under the tip, you'll see you have very little room to work with. You need to barely stick the knife in so that it holds onto the cap and doesn't slip out, but also is not pulling on the piece that's held on by the screw.

Also, I believe this kind of pyraminx has very little glue. Just keep repeating this on all three sides to loosen the cap and it should eventually pop off. Of all the pyraminx puzzles that I have, I think this kind was the easiest one to get caps off of.

I move my wrist like accelerating a motorcycle right?

Yes, that should do it. Sometimes it does take a while...

It's not working for me.
 
could you make a video? I don't really get how you do it.
Sorry, I find it too trivial to make a video. I'll go through step-by-step though...

1) Place pyraminx on table and rotate until the edge of the pyraminx is facing you.
2) Rotate the tip on the top 60 degrees so that the flat side of the tip is facing you.
3) Wedge knife underneath tip enough that you can pry the cap off. Make sure you don't stick it in too far, otherwise it will just catch on the piece that is holding the cap in place.
4) Repeat on all three sides of the tip until the cap comes off.

I actually do it differently. I turn it 60 degrees and stick a knife beneath one of the sides of the tip, not one of the vertices. That way I can pry it off. Depending how much glue is on it, you may have to do this to all three sides. If there's too much glue, it may ruin the core if you happen to pull the entire screw out, but it should be fine with a QJ pyraminx. This probably won't work with screwdrivers since they're too thick, so if using a knife is too dangerous, this probably isn't going to help.

Using my definition, no, the megaminx does not have corners, it has tips. I'm being extremely pedantic. Perhaps a corner is defined as when two lines of different dimensions meet at an angle >60, whatever, it's an interesting topic.
Well I could define a circle as a curved line where both ends meet, but that's not necessarily what a circle is, is it?
http://dictionary.reference.com/browse/corner

A circle is absolutely defined. It appears a corner and a tip are ill-defined. Why do you think there's a topic being debated here?
So are you saying that a corner isn't absolutely defined? Just because several people don't know exactly what a corner is doesn't mean the word itself isn't properly defined. I would call that confusion, not a debate. A debate is held over something that does not have a clear answer, and the definition of "corner" is something you can't change.

You've failed so far (well it seems you have) to give me an absolute definition of a corner. I can't help it if my mind has been conditioned to think corners are different to tips.

I think the point (geddit?) is that the idea of a "corner" is ill-defined, whereas the idea of a circle isn't.
 
Back
Top