problem with type d cube...

shafiqdms1

Regular
Joined
May 3, 2008
Messages
124
WCA ID
2008MOHA01
YouTube
Visit Channel
I recently got a type d cube and it has caused me many problems. 1) when I got it and started cubing, I realized that c4u put a wrong screw in (5 of them were normal sized and one was small with a washer attached to it) and so it came out of the core and wouldn't stay in the d core. Luckily I had an extra a core so I transferred everything to the A core with 5 D screws/springs and instead of that small screw I put a type A screw with type D spring. It was good for a couple of solves but now it causes newer problems. Now it locks up a lot and pops easily.

Any help on what I should do? Should I put all A screws and remove the D screws? any idea on how to reduce the lock up?

Thanks in advance,
Shafiq
 
Yes, looks at the two sites Odin listed. They explain what to do.

Also look at this site. It explains why the new Type Ds are so bad.

Basically what they did was switch the screws, which were actually one of the keys to the Type-D's success.

The original screws are designed in such a way that they that there was only one tension setting - and that setting was dang near perfect!

To accommodate the original screw, the holes in the bottom of the center cubies are a wider than what you would find in other cubes.

Well they replaced that screw with a rather standard 'thin' screw.

The problem with this is that it leaves too much extra space for the screw, allowing the cubie to shift and preventing it from turning optimally.

It can also cause some 'unwinding' which can be annoying.

Lubing the cube helps to deal with some of the problems caused by the 'extra space', but hasn't seemed to help the 'unwinding' problems in the cubes that have exhibited it.

NOTE: Type-D Cubes Do Not Come With Washers

This is a shame really, and surely contributes to the 'unwinding' problems.

Unfortunately, the Type-A washers are not compatible with the Type-D Cube
 
Back
Top