I have recently bought a C4Y DIY cube and it turns great, way better then my storebought.
Only real downside is that it locks up a lot.
I modded my storebought and reduced lockups to almost none but that one never was the same (feeling when turning, no longer smooth but more grainy)
I did smooth out the pieces of the storebought as much as I could.
For the storebought I modded all sides of the cubies (except the outside).
I think that the mod on the "centers" of the cubies (that hold them in place) causes this feeling.
So I'm planning to do only the edges of the cubies (the "lines" that go from the sticker to the inside of the cube) as the lockups are basically cubies hanging on eachother on these points.
Would this be smart or could I ruin my DIY this way?
EDIT//
Ok, here are some pictures (click them for bigger pictures):
Sorry if you can't really see it, both my cubes are black. Not the best color for showing details on pictures
The way the cube locks up, corners of cubies hanging on eachother:


one of the cubies from my C4Y (unmodded, left top) and a modded storebought cubie (rounded edge, right bottom):

Modded cube, here the pieces would slide over eachother because of the rounded edges:

Only real downside is that it locks up a lot.
I modded my storebought and reduced lockups to almost none but that one never was the same (feeling when turning, no longer smooth but more grainy)
I did smooth out the pieces of the storebought as much as I could.
For the storebought I modded all sides of the cubies (except the outside).
I think that the mod on the "centers" of the cubies (that hold them in place) causes this feeling.
So I'm planning to do only the edges of the cubies (the "lines" that go from the sticker to the inside of the cube) as the lockups are basically cubies hanging on eachother on these points.
Would this be smart or could I ruin my DIY this way?
EDIT//
Ok, here are some pictures (click them for bigger pictures):
Sorry if you can't really see it, both my cubes are black. Not the best color for showing details on pictures
The way the cube locks up, corners of cubies hanging on eachother:


one of the cubies from my C4Y (unmodded, left top) and a modded storebought cubie (rounded edge, right bottom):

Modded cube, here the pieces would slide over eachother because of the rounded edges:

Last edited: