I've magnetized two cubes with runny super glue, and it hasn't been that hard. You have to glue the first magnet in place very carefully, let's say in an edge piece, then hold a corner piece next to the edge as it would be when the cube is assembled. You put a dot of super glue in the corner about where the magnet is going to go (be careful not to let any drip onto the outside of the piece) and put a second magnet into the corner piece. Don't try to put it exactly where it belongs, just release it a little ways away from the plastic and the pull of the first magnet will align it in the correct spot and polarity, and slap it down into the super glue. I also like to add some extra glue around the edges and over the top of the magnets. It is easy to get glue on your fingers and on the outside of the piece, so you have to be careful, but it's not that hard.