[Help Thread] How Do i figure out how to tension my cube

[randomness...]

Ive been swapping from loose and uncontrolled corner cutting, to tight and quick, snappy cutting.
i have been trying to get it right for 3 years now

 

[An Animating Cuber]

Two tips, Try to only turn your screws in increments (one turn, half turn quarter turn) and pull apart two sides to make sure the tension is even, then mess around with the tensions until you land on what's right for you.

 

[randomness...]

ive been doing that but i havent found that sweet spot

 

[An Animating Cuber]

Are you just trying to find corner cutting you like or do you also have problems with the speed and feel of the cube as well?

If it's just a corner cutting issue I'm not sure what to say you'll just have to get comfortable with one way.

If you also have problems with the speed and feel there several ways to fix that dual adjustment systems, lube combinations, and spring swaps.

 

[randomness...]

im having issues with the feel of it (mostly) but
i only have a GAN and a maglev rs3m

 

[An Animating Cuber]

If you have an older GAN use the springs from the GES system stronger ones will give the cube a tighter slower feel, weaker ones give the cube a loser and quicker feel, if you have a newer GAN it should have a dual adjustment system, the more you compress the springs the stronger the springs are, the less compressed the weaker, same goes for the RS3 M, except it's a bit more finichy because of the maglev.

 

[CubeLess12]

Guys can anyone help we with tensioning my cube properly? I tried but one side always remains tight, even after turning the screw many times... I have Weilong maglev cube

 

[Kami]

Try unscrewing them all, and give them 5 full turns each, and then tighten them to your liking

Guys can anyone help we with tensioning my cube properly? I tried but one side always remains tight, even after turning the screw many times... I have Weilong maglev cube