Gans 357 Issues

I have had it for about a month, about 500 solves, and I bought it from thecubicle.us

I really don't know what to tell you, I have two 357's both from the cubicle and the primary one definitely has softer plastic than my black one which feels more harder and snappy. has nothing to do with the color I'm sure cause that'd be dumb, I think you just have to be lucky and get a good unit
 
First, MeiYing is great.

Secondly, try to figure out how it is popping, and where. I cube doesn't just do things....because. The square corners make the 357 almost impossible to corner twist. That nut can be tightened quite a lot!
 
Yeah, but it is extremely sluggish, and I have a rough turning style. Rough, but accurate.

Should I get different springs?

I don't understand rough but accurate, to me those are opposites with cubes.

I tried the different spring sets and like the 11mm springs. I believe they are only a buck and totally worth the test. I made a video on it on my youtube page.
 
When all else fails start from scratch. My advice is to take the cube apart, wrote everything down thoroughly to remove all lube. Then put a anal amount of lube under the spring washers in the centers. Assemble with no lube. The stock tensions have about 4mm of the plastic core sticking out past the nut. Because of the different style springs and centers you can tighten it down a lot before it slows things down, but that will get rid of any popping. With no lube it should be plenty fast, but not so smooth. If at that point is still slow then I guess you could have one with soft plastic? Mine has never popped, ever, and it's plenty fast.

What are you lubing with btw?
 
I have used a lot of Gans 357 and what you are experiencing is not normal in my experience. I would suggest trying to exchange the item or trying to really tighten down that nut and re-lubricate the puzzle. You might have a bad core which is not allowing for proper tensioning.
 
My Gans 357 will not stop popping, corner-twisting and it is extremely slow. I have adjusted the tensions, but to no avail. I have the V2 core, and I am positive it is not a counterfeit. Is it possible that is is a dud?View attachment 5382View attachment 5383View attachment 5384View attachment 5385

Sometimes a cube takes longer to break in. I've had some cubes that were horrible at first, I took them apart, lubed them compared them to one I already had and they still didn't work the way I wanted. I just kept using them and they ended up being fine. Usually its just how it came out of the mold and you won't be able to tell with your eyes comparing to another cube and Cubicle sells great cubes!
 
2180161, you're actually right. I have a new neutral colored Gans 357 with the new core and as long as I have tried to break it in, it's still crappy. It's either too tight and slow but if I even loosen it a little bit pieces go flying everywhere, sometimes the corners fall apart and go flying! There seems to be a middle ground and I'm tired of taking it apart to try and lube it and adjust it. The good thing is I have a lot of cubes and this is the first semi-dud I really ordered. I'll keep trying to do stuff with it but I've given up on this as one of my mains. Good luck with yours.
 
Back
Top