GAN Air SM side feels stiffer than the other

[CantGetSub15Seconds]

title says it all

any help? im sure this is caused by the ges nuts, but im not sure how

 

[macncheese]

1. Maybe that side was not broken in. Try moving the layer several times.

2. Put all sides on the tightest tension and loosen them equally to make sure they are tensioned equally.

3. Apply lube to the stiffer side to make it smoother

 

[qwertycuber]

Try to put some lube under the GES nut, because that seems to solve the speed issue for me.

 

[CantGetSub15Seconds]

I tried all of the above. It didn't help.

 

[macncheese]

I tried all of the above. It didn't help.

Oh no. Maybe there's something stuck under it? Remove the pieces and check

 

[CantGetSub15Seconds]

Oh no. Maybe there's something stuck under it? Remove the pieces and check

I've cleaned the cube out multiple times and found nothing. I just did it, nothing.

 

[macncheese]

Then it's probably defective. Can you get a refund?

 

[CantGetSub15Seconds]

Then it's probably defective. Can you get a refund?

It's been more than a week.

 

[macncheese]

Unfortunately you have to buy a new one then. I pity you cause those cubes are expensive

 

[CantGetSub15Seconds]

Unfortunately you have to buy a new one then. I pity you cause those cubes are expensive

I can probably just buy a new ges set or try breaking it in like crazy if that even helps

 

[macncheese]

I can probably just buy a new ges set or try breaking it in like crazy if that even helps

Yes you can do that. Try putting Vaseline in because it makes my cube very light. Don't put too much because it melts plastic and GAN plastic is thin.

 

[Duncan Bannon]

^ I would not put vaseline in my cube.