Dead RBK 3x3

number1failure

Regular
Joined
May 31, 2010
Messages
234
I meant to throw my cube into a pile of laundry very hard because I was pissed. I ended up pitching it at the wall right above. It is now broken, 1 core arm broke off, 2 center pieces broke off, one edge has a very small chip in it, and either 2 either 2 or 3(I forget) edge pieces are missing. The cube was Cubesmith tiled, silicone lubed, and had a color scheme of Yellow-Purple, Red-Green, Black-White. What does Speedsolving recommend I do with the pieces, and what new cube should I get? Also, I tend to cube "aggressively" so I overshoot a lot, so a cube with VERY good corner cutting and rev. corner cutting would be great. And I know that this should go in the "What cube should I get?" thread, but I'll just mix it into this one to avoid 2 threads, rather than 1.
 
Not much demand for Rubik's 3x3 pieces. Well, not much demand for 3x3 pieces at all, really. They're so cheap it's easier to buy a new puzzle.
 
Not much demand for Rubik's 3x3 pieces. Well, not much demand for 3x3 pieces at all, really. They're so cheap it's easier to buy a new puzzle.

I'm not asking about selling them, I'm asking if there is anything that I can do with them.
 
Not much demand for Rubik's 3x3 pieces. Well, not much demand for 3x3 pieces at all, really. They're so cheap it's easier to buy a new puzzle.

I'm not asking about selling them, I'm asking if there is anything that I can do with them.

Selling them IS something you can do with them, and I was merely saying that if that's what you wanted to do, it probably wasn't going to work out.
 
I recommend C4U Interchangeable Tiles because it doesn't overshoot, cut corner around almost 45 degrees, can reverse cut corner too and you don't have to change sticker again because it use tiles :D
 
I meant to throw my cube into a pile of laundry very hard because I was pissed. I ended up pitching it at the wall right above. It is now broken, 1 core arm broke off, 2 center pieces broke off, one edge has a very small chip in it, and either 2 either 2 or 3(I forget) edge pieces are missing. The cube was Cubesmith tiled, silicone lubed, and had a color scheme of Yellow-Purple, Red-Green, Black-White. What does Speedsolving recommend I do with the pieces, and what new cube should I get? Also, I tend to cube "aggressively" so I overshoot a lot, so a cube with VERY good corner cutting and rev. corner cutting would be great. And I know that this should go in the "What cube should I get?" thread, but I'll just mix it into this one to avoid 2 threads, rather than 1.

I thought you had $900? Just buy every cube and try it.

/thread
 
I would recommend A5, as i like it very much, i own f2, guhong, shengsou you name it and i think A5 is probably the best its very balanced in speed ( lubed with D39 ) cuts corner well and doesn't pop. Gu hong is faster ( glides more ) and cut corners better but you need to be kind of light on it, cus its so fast. and yeah i don't think F2 is the cube for you as its very smooth and glides very frictionless so you need to be extra sensitive.
 
Back
Top