Cube4you Tile Cube

[CubeCraze]

Hi it's CubeCraze here and wanted to know how good the cube4you tile cube is. Pestvic and some others said it was good but i want to be sure. I mainly want to know how the corner cutting, lockups, tile quality, and pops are in your opinion.

 

[bluecloe45]

it sux

 

[CubeCraze]

Can you specify why it sux?

 

[FatBoyXPC]

I have a brand new one, and I honestly dislike it (compared to FII and GuHong). It's obviously better than a storebought, but I guess I've been spoiled by the FII and GuHong. Tile quality is decent but get light scratches just as easily as when you slide your phone across a table. I put maru lube inside the cube and honestly was disappointed. I guess I could lube it with shock oil and compare my results.

 

[Wickex]

It's a little outdated. I suggest going for a GuHong, or if it's too expensive for you, the F-II.

 

[CubeCraze]

Thanks guys I'll be ordering the gu-hong!

 

[bigbee99]

I agree the others, the Tile cube is really just a collector item now, it's nit really used for speed solving now.

 

[CubeCraze]

Since I'm ordering a guhong does anyone have any cons on it?

 

[Chapuunka]

Since I'm ordering a guhong does anyone have any cons on it?

Can be uncontrollable if you're not used to insane speed. Also screws up turning style if you become too dependent on the reverse corner cutting.

 

[Cyrus C.]

Can be uncontrollable if you're not used to insane speed. Also screws up turning style if you become too dependent on the reverse corner cutting.

It's not ruined if you only use the GuHong.

 

[CubeCraze]

Couldn't you tighten the tension? My cousin bought a guhong and I tried it. It was definetly more fast than my f-II and the tension was at the point where if you try to take out an edge, it will easily slip out. It wasn't too much of a problem. But still a little problem.