Cube Logo Dimensions

CubingDraco

Member
Joined
Feb 12, 2020
Messages
2
So I've looked into wanting to make my own cube logo for each of my cubes. I figured out how to make on, but I don't know the exact dimensions of the sticker on each cube. The cubes I want to add a logo on is from 3x3 - 7x7. Is there any resource I can use?
 
you could use the size of pre existing logos, or you take the size of the cube and divide it by the number of layers, say a 3x3 is 56mm, you would divide that by 3 to get the size of each layer. so it would be 56/3=18.6, and I would round it down to 18 to make sure it fits.
Thank you!
 
you could use the size of pre existing logos, or you take the size of the cube and divide it by the number of layers, say a 3x3 is 56mm, you would divide that by 3 to get the size of each layer. so it would be 56/3=18.6, and I would round it down to 18 to make sure it fits.
I would even go further and go down to 16 or 17, just to be safe.
 
It must depend on which cubes you're using. Not only is there variety in size of cubes, but some may have slightly smaller cubies due to rounded off pieces.
 
Back
Top