A Way to Make Storebought Cube Looser

TudMun

Member
Joined
Jan 28, 2009
Messages
14
I thought this would be useful for storebought users. This is a way I made my storebought much looser.

1.Soak cube in warm water. Be sure to get all sides wet. Do this for 30-60 seconds.

2.Then, without turning off the water, immediately turn the water ice cold and briefly soak the cube for a few seconds.

3.Dry the cube. Turn it rapidly on all sides using finger tricks. Dry the cube if it gets wet.

4.Do step 1-3 for 3-5 times, gradually using hotter water until the water is so hot you can barely touch it.

5.Do step 1-3 using ice cold water.

6.At this point, the cube will be dramatically faster but then much tighter. Do a couple solves and then let the cube sit until the next day.

7.The day after you do step 6, do any four-move algorithm 240 times as fast as you can. Do this on all 6 orientations of the cube.

This should make the cube much looser. Hope it helps!
 
I think the only thing affecting the performance is the 4-move alg on all sides of the cube (breaking it in), not the water temp.
The water temperature makes the core thinner, loosening the cube by increasing the space between sides. Breaking it in works too, but it's not as potent towards loosening the cube.
 
Last edited:
This is a lot like the after-game recovery my uncle told me about to get blood moving: 5 minutes in extremely hot water, then 5 in ice cold, then back and forth 5 or so times.

What does the heating do? Does it make the cube expand so the cubies push against each other more? I realize the effects of cold water (as explained earlier) but is the warm water necessary?
 
Hmm, I don't see how thermal shock is going to help a lot on a cube (that's why the warm water is needed first)

I got mine much better by rounding off all inside stuff with sandpaper and smoothing it out after that (with fine sandpaper and then steelwool).
Then I lubed it (even though it doesn't react to it like my DIY does, which became WAY smoother with lubing)
 
I don't know all that crap about water temperature and all that, but I tried it and it got tighter so my cube doesn't pop as much...so then I broke it in(with Pestvics method rather than the stupid 4 move alg)and lubed it so it's better than ever. I still don't get a water temp and everything.
 
The water temperature makes the core thinner,

care to explain? this doesnt make sence

Warm water softens up plastic. That's what I meant by thinner.

If you only use warm water, the core will eventually tighten back up. That's why you need the cold water to maintain the losseness (there are other purposes).
 
Back
Top