Comparison of Shengshou 4x4 I, II and III cube

calvinfan

Regular
Joined
May 3, 2009
Messages
130
Location
Hong Kong
YouTube
Visit Channel
Since quite a lot of customers asked me about the difference of Shengshou 4x4 I, II and III cube. The main difference are the edges, see the photo below,
Shengshou I and II,
__ImageGrabber.axd

Shengshou III, with track and "Z" leg
__ImageGrabber.axd
 
idk if anyone will see this but i have a shengshou v?

the edges and corners are the same as a v3 BUT the centres dont have the little rods that stick out
what cube is this
 
idk if anyone will see this but i have a shengshou v?

the edges and corners are the same as a v3 BUT the centres dont have the little rods that stick out
what cube is this

Huh, I got this too (probably v2 then I guess) when I ordered the v3 from GreatSku (which has otherwise been a good site to buy from for me). Lightake sent me a v1 when I tried. I'll try Konsta and Florian mods on the v2 and see where that gets me. I think I'll give up on trying to buy the v3.
 

comparing my edge pieces concludes that its not a v2?


Huh, I got this too (probably v2 then I guess) when I ordered the v3 from GreatSku (which has otherwise been a good site to buy from for me). Lightake sent me a v1 when I tried. I'll try Konsta and Florian mods on the v2 and see where that gets me. I think I'll give up on trying to buy the v3.

i got this from some (physical) store in china at a mall so idk bout the authenticity of the cubes

also got an a5 (i think)
 
Back
Top