# [Video] How To Break In a Megaminx, 1200 Turns Per Minute!

#### emolover

##### Member
Or just loosen it alot, do the megaminx edge mod, use the AV corner mod, Lubix(shock oil) the core, set to correct tensions.

#### Owen

##### Member
I would imagine that it would create a lot of plastic dust or melting.

#### Bapao

Very! Was thinking about doing something like this for my 3x3x3s. The drill idea is simple and cheap (if you already have one in your shed that is. Which I don't). And just using a center cap as a bit is ingenious. A+.

My new Mefferts Minx is already a very good turner after some simple modding though.

#### dimwmuni

##### Member
That's very cool, but does it make enough of a difference to be worth it?

#### drewsopchak

##### Member
Or just loosen it alot, do the megaminx edge mod, use the AV corner mod, Lubix(shock oil) the core, set to correct tensions.
No, there is no substitute for worn in mf8. I do like the av mod on it too.

I would imagine that it would create a lot of plastic dust or melting.
Just like dust gathers after months of solving and wearing in.

I average 1:15 with a worn in, modded mf8 and this set up was quite cheap for me personally. I can do about 6 months of breaking in solves. In about two hours on this machine.

Last edited by a moderator:

#### Bapao

I'm guessing one would put lube in first right?

#### bluecloe45

##### Member
I average 1:15 with a worn in, modded mf8 and this set up was quite cheap for me personally. I can do about 6 months of breaking in solves. In about two hours on this machine.
Simply use the "Edit" button then resubmit your post.

#### ChrisBird

I think I going to go buy a Megaminx and thousands of dollars of equipment so I can do this.
You can buy a drill on Amazon for about $22, the Mega for$10, and just use your hand to hold it. There you have a broken in megaminx for less than \$50.

And if I remember grade school math, 22 < 1000(s)

Last edited:

#### Bapao

How did you get the center cap attached to the drill bit btw?

#### Owen

##### Member
Woah, you are the guy from Cornell Spring 2011... The one who won pyraminx.

I didn't recognize you!

#### HelpCube

##### Member
I'm guessing one would put lube in first right?
no, since the lube would probably wear away very quickly when its turning that fast, and the cube breaks in better when its tight and unlubed.

#### HelpCube

##### Member
Without lube, wouldn't it be more likely to melt, though?
i talked to andrew (maker of this video) and he said melting wasnt a problem at all suprisingly, just lots of black dust to clean out after. I guess just dont leave it running all day and you should be fine