setup

So, about three months ago, i got two mgc elite 2x2s (one as my main, one as a warm-up for comps). However, I didn't use them too much, as I did not practice 2x2. Before this, I mained the Gan 251m Leap, which I hated because often I would make the motion for a move, and it just wouldnt actually...

Additional Points: 1. Should I buy 2 5ml bottles of Weight 1 and 1 5ml bottle of Weight 5 (as here, we use weight 5 less)? 2. How will the setup be and how much would you rate it out of 10? 3. Are there any better setups using only silicone weight lubes?

This is the thread for lube setups, preferred tensions, settings, mods, etc. for all types of cubes. You can request, just post normally, give tips, and everything in between. I'll just kick this off right now with my preferred setups. For all my cores, I drop in any lighter lube and break it...

Hi there I have bought a ys3m maglev and this lube https://www.speedcube.co.nz/collections/lubricant/products/dayan-speedcube-lubricant-10ml how much setup xo I need to do to it to get it to run smooth and good corner cutting many thanks

Hi guys. I have a simple question to which i haven‘t found a specific answer to. So on a 4x4 there are these „hidden“ center layers when you pull it apart between two wings. I just got an mgc 4x4 and dnm. I tried to put a few drops of dnm between a wing and a corner (i pulled it apart so i could...

I use the triangular corner to centre magnets, the corner edge ones are in the middle, and I use the dark blue GES thingies, and the white tension nuts are flush( I believe that this is setting one).

Hey guys, i've been using GAN 356X (Numerical IPG) for quite some time now. Recently i've decided to pick up OH solving and i need your help. I don't know if i should keep my cube tight with yellow nuts and strong magnets or if i should loosen it up. Also if you have any tips for picking up OH...

As well as selling clock magnets I'm now selling fully set-up magnetic clocks! I use Traxxas 50K to lube them, N52 Ring Magnets, and N52 5x1mm Disc Magnets. The 5x1 magnets are the real strength, not cheap magnets from eBay. Each clock is $50 with free USA shipping. International shipping is...

Hi Everyone I recently bought my first brand new Dayan Zhanchi 3x3 from a supplier on E-Bay. When I received the cube within the first few seconds of play it popped. I re-assembled the cube and a few minutes later it popped again. After numerous pops I approached google, Youtube and the...

Haha It was just a joke. Set up scrambles.

Sorry if this question has been answered already, but I have searched all over the forums, wiki and popular cubing websites. I want to learn Fridrich F2L, OLL and PLL algorithmically. But, to practice each algorithm, I need the setup formulae for each of the cases. Dan's cubestation had them...